---
title: Profile Type: LUT or Matrix
slug: nexus/profile-type-lut-or-matrix
createdAt: 2026-11-20T15:03:42.113Z
---

DT Nexus can build the ICC profile for white-light captures in one of two ways:

- **LUT** (the default) builds a look-up table profile. It is the more aggressive type, and it matches the colors of the profiling target very closely.
- **Matrix** builds a compact shaper-and-matrix profile. It describes the camera's overall response rather than correcting each color individually.

The choice applies only to the white-capture ICC profile. Fusion profiles always use their own matrix model, whichever type you choose.

## Choosing a Profile Type

A LUT profile almost always shows the lower ΔE on the target used to make it, because it is fitted closely to that target's patches. A Matrix profile usually shows a higher ΔE on that target, but often does as well or better on a different target, which is a fairer test of how the profile will perform on your collection.

Because a LUT is fitted so closely, it has a propensity to overfit the target, and in doing so it can mask poor practice or a poor environment. For more on this, see "Arte-Profiler: An open-source tool for colour profiling and accuracy assessment in cultural heritage photography" by Alessandra Marrocchesi, Robert G. Erdmann and Douglas Peterson, a chapter of [Advanced Imaging for Examining, Monitoring and Analysing Cultural Heritage Artefacts](https://www.taylorfrancis.com/books/edit/10.4324/9781003441366/advanced-imaging-examining-monitoring-analysing-cultural-heritage-artefacts-christian-degrigny-sony-george-jon-yngve-hardeberg) (Routledge, 2026).

To choose for your setup, make both types and compare them on an independent target, one of a different make and model from the profiling target. See [The Importance of Evaluating Color Quality Using an Independent Target](https://heritage-digitaltransitions.com/the-importance-of-evaluating-color-quality-using-an-independent-target/) on the DT website, and [Higher DeltaE Numbers for Fusion](https://docs.digitaltransitions.com/nexus/suggested-capture-settings#higher-deltae-numbers-for-fusion), which explains the same effect for Fusion.

## Setting the Profile Type

::::WorkflowBlock
:::WorkflowBlockItem
To set the type every new profile starts with, open `DT Nexus > Preferences`, select `Profiling`, and choose `LUT` or `Matrix` under `Default Profile Type`. Click `OK`.
:::

:::WorkflowBlockItem
To change the type of one profile, use the `Profile Type:` menu on the results page of the Calibrate window (see [Color Profile Creation](https://docs.digitaltransitions.com/nexus/color-profile-creation)). DT Nexus builds the profile of the type you choose and updates the results. Switching back shows the profile it already built.
:::
::::

## Other Profiling Preferences

`Preferences > Profiling` also has these settings:

| Setting                    | Default             | What it does                                                                                                                                                                                                                      |
| -------------------------- | ------------------- | --------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- |
| `Linear Scientific Curve`  | `Linear Scientific` | Sets the linear curve applied before calibration exports. `Linear Scientific 2026` is preferred for Phase One IQ and IX cameras and falls back automatically for other cameras.                                                   |
| `Black Point Compensation` | All on              | One checkbox for each target type: `DT NGT2`, `CCDSG (ColorChecker Digital SG)`, `ISA Object Level Target`, `ISA Device Level Target`, `FADGI 19264`, `DT NTVT (Transmissive Validation)` and `DT NTPT (Transmissive Profiling)`. |

