---
title: Screen Blackout
slug: nexus/screen-blackout
createdAt: 2026-11-20T15:06:05.861Z
---

Depending on the position and brightness of your monitor, light from your monitors can spill onto the subject and show up in the image. Screen Blackout covers every screen with black while a DT Nexus capture is exposing, then brings the screens back.

## Turning On Screen Blackout

Open `DT Nexus > Preferences` and select `Capture`. Under `Screen Blackout`, tick `Black out screens during capture`, then click OK. It is off by default.

::Image[]{src="https://api.archbee.com/api/optimize/FNM-z2yUwMltWWy4JpCr8/GMhaanM0AY9lyuDgZUT3n_dt-nexus-1-3-screen-blackout-preferences-capture.png" size="92" isUploading="false" width="1400" height="1264" showCaption="false"}

## Which Captures Are Covered

Screen Blackout covers captures started from DT Nexus:

- The `Capture` button in the Trigger tool
- The DT Nexus Capture shortcut (⌘K), including [Universal Capture](https://docs.digitaltransitions.com/nexus/universal-capture)
- A foot pedal plugged into a DT Stellar
- Captures taken by the Sequencer

Captures started in Capture One or on the camera are not covered.

## During the Capture

While the screens are black, a grey ring in the center fills over the exposure time of each frame. A status line shows progress where it helps, for example "Sequencer: 2 of 5 captures" during a sequence. Below it, the screen tells you how to turn Screen Blackout off and that you can click anywhere to dismiss it.

## If the Black Screen Is Dismissed or Cannot Appear

- **You click the black screen, or it times out.** The frame is still taken, and DT Nexus warns: "The black screens were dismissed or timed out, so this frame may have been exposed with the screens lit." Check that frame and capture it again if needed.
- **The screens cannot be blacked out.** The capture is not taken: "Screens could not be blacked out, so the capture was not taken." This protects you from an exposure with the screens lit when you expected them dark.

## In the Sequencer

Each Capture action in a sequence has a `Blackout` setting: `Current Setting` (follows `Preferences > Capture`), `On`, or `Off`. Use `On` for a sequence in which monitor light must never reach the subject, whatever the preference is set to. When a Capture action has turned blackout on, the black screen tells you to set `Blackout` to "Off" in that Capture step to turn it off.

During a run, the screens can stay dark from one capture to the next. See [Running a Sequence](https://docs.digitaltransitions.com/nexus/running-a-sequence) for which actions keep the screens dark and which bring them back, and [Building a Sequence](https://docs.digitaltransitions.com/nexus/building-a-sequence) for the Capture action settings.
