---
title: Setting Continuous Light Output
slug: stellarmkii-stellarxl/setting-continuous-light-output
docTags: 
createdAt: 2024-04-02T23:04:50.309Z
---

## Steps

:::::WorkflowBlock
::::WorkflowBlockItem
Ensure the mode switch is set to “Standalone” and the unit is powered.

:::hint{type="info"}
When powered on the Stellar enters the *Continuous Light: Coarse Adjustment *setting. The Indicator Ring turns light blue, every third LED is yellow indicating one stop of light.
:::
::::

::::WorkflowBlockItem
**Rotate** the Control Dial **clockwise** to increase power by ⅓ stop increments and **counter-clockwise** to decrease power by ⅓ stop increments across a seven stop range.

:::hint{type="info"}
Continuous light output has a maximum output setting of 10.0, to access the last stop of power (a setting of 11.0), Flash function is needed.
:::
::::

:::WorkflowBlockItem
**Press** the Control Dial **once** to enter the *Continuous Light: Fine Adjustment *setting. The Indicator Ring turns yellow.
:::

:::WorkflowBlockItem
**Rotate** the Control Dial **clockwise** and **counter clockwise** to increase and decrease power respectively by 1/24 stop increments. While in fine adjustment, a maximum range of +/- ⅓ stop is possible. 
:::

:::WorkflowBlockItem
To exit the fine adjustment setting, **press** the Control Dial **once** or **wait three seconds** to return to the previous menu.
:::
:::::

:::hint{type="warning"}
If the coarse adjustment setting is changed after a fine adjustment has been made, the fine adjustment setting will reset, removing any 1/24th of a stop adjustments.
:::