Assembly
Components
In the Box
- DT V-Cradle
- Glass Surface
- ISA Object Level Target Holder
- Foam Binding Support
- Foam Book Wedge
- Book Pad
Components
- Glass Hinge/Spring Pin
- Spring Arm Lock
- Book Opening Angle Control
- Gutter Slide Position Lock
- Book Height Control
- Glass Panel Lock
Assembly
DT V-Cradle is shipped fully assembled. The glass panel and ISA Object Level Target Holder are shipped unattached and can be optionally installed.
Handle Installation
The handle of the height control wheel is mounted backward on the wheel to prevent damage during shipping.
With the included hex wrench, remove the handle from the height control wheel.
Re-attach to the height control wheel in the outward-facing direction.

Glass Installation
The DT V-Cradle ships with the lock pins in the Spring Arm Lock.
With the Spring Arms in the locked position, place the glass panel on top of the cradle. Make sure the glass hinges are lined up with the glass hinge ears on the cradle.
Make sure that the operator facing edge of the glass is sitting under the spring thumb locks. This will help hold the spring arms in place.
Remove the lock pin from the Spring Arm Lock by depressing the blue button and pulling out on the lock pin.
Align the lock pin with the hinge on the glass panel . Depress the blue button and insert the lock pin into the glass plate hinge. Insert the pin until the blue buttons pop up. Check the pin is fully locked by lightly pulling outward on the black collar.
Repeat for the opposite-side lock pin.

Target Holder Installation
This holder is a magnetic holder and is specifically compatible with Image Science Associates 0.5x and 1x Object Level Targets.
Raise the glass panel.
Remove the side rubber covers, exposing the slots along the edge of the V Cradle.
Place the “feet” of the target holder in the top most slot. Note that the magnetic strip should be facing towards the glass.
Replace the side rubber covers and check that the glass panel closes easily.