Profile Type: LUT or Matrix
DT Nexus can build the ICC profile for white-light captures in one of two ways:
- LUT (the default) builds a look-up table profile. It is the more aggressive type, and it matches the colors of the profiling target very closely.
- Matrix builds a compact shaper-and-matrix profile. It describes the camera's overall response rather than correcting each color individually.
The choice applies only to the white-capture ICC profile. Fusion profiles always use their own matrix model, whichever type you choose.
Choosing a Profile Type
A LUT profile almost always shows the lower ΔE on the target used to make it, because it is fitted closely to that target's patches. A Matrix profile usually shows a higher ΔE on that target, but often does as well or better on a different target, which is a fairer test of how the profile will perform on your collection.
Because a LUT is fitted so closely, it has a propensity to overfit the target, and in doing so it can mask poor practice or a poor environment. For more on this, see "Arte-Profiler: An open-source tool for colour profiling and accuracy assessment in cultural heritage photography" by Alessandra Marrocchesi, Robert G. Erdmann and Douglas Peterson, a chapter of Advanced Imaging for Examining, Monitoring and Analysing Cultural Heritage Artefacts (Routledge, 2026).
To choose for your setup, make both types and compare them on an independent target, one of a different make and model from the profiling target. See The Importance of Evaluating Color Quality Using an Independent Target on the DT website, and Higher DeltaE Numbers for Fusion, which explains the same effect for Fusion.
Setting the Profile Type
To set the type every new profile starts with, open DT Nexus > Preferences, select Profiling, and choose LUT or Matrix under Default Profile Type. Click OK.
To change the type of one profile, use the Profile Type: menu on the results page of the Calibrate window (see Color Profile Creation). DT Nexus builds the profile of the type you choose and updates the results. Switching back shows the profile it already built.
Other Profiling Preferences
Preferences > Profiling also has these settings:
Setting | Default | What it does |
|---|---|---|
Linear Scientific Curve | Linear Scientific | Sets the linear curve applied before calibration exports. Linear Scientific 2026 is preferred for Phase One IQ and IX cameras and falls back automatically for other cameras. |
Black Point Compensation | All on | One checkbox for each target type: DT NGT2, CCDSG (ColorChecker Digital SG), ISA Object Level Target, ISA Device Level Target, FADGI 19264, DT NTVT (Transmissive Validation) and DT NTPT (Transmissive Profiling). |